Remote Guide: N5SUpdated 5 months ago
In this article, you find:
- How to connect the N5S Remote
- How to adjust the Settings
- How to use it
- How to Re-Set the Remote
 | You can purchase the remote here. |
The Remote is Compatible With:
- Flow, Envy, Aurora
Connecting the Remote
- Hold down the power button on the board until it blinks rapidly.
- Turn on the remote.
- Long press the remote's power button to connect.
Adjusting the Remote Settings
- Navigate settings using the throttle (back and forth) and confirm with the power button.
- Set board type (default is usually correct).
- Confirm motor type (default is 4240).
- Choose unit system (km/h or mph).
- Set wheel diameter (important for speed and range accuracy).
- Adjust drive ratio (contact support if changing wheels or pulleys).
- Set motor pole pairs (7 for belt drive, 1 for hub motors).
Using The Remote
- Use throttle to control speed.
- Double-click to change direction (forward/backward).
- Long press the setting mode to change speed modes (1, 2, 3).
- View trip distance (T) and total distance (0) on the display.
- Check battery levels (R for remote, B for board) in the top corners.
Re-Setting The Remote
- To reset settings, Turn off the remote, hold the throttle, turn on the remote, release the power button, and then release the throttle.
- To re-pair: Turn off the board, hold the power button until it blinks, then pair with the remote.
- Resetting the remote will erase all stored data.